Century V6-3100 3.1L VIN M SFI (1998)
Shift Cable: Service and Repair
A/T Range Selector Cable Replacement (at PNP Switch)
REMOVAL PROCEDURE
CAUTION: Refer to Automatic Transaxle Range Selector Cable Caution in Service Precautions.
1. Remove the throttle body air inlet duct. Refer to Throttle Body Assembly Replacement in Powertrain Management.
2. Remove the automatic transaxle range selector cable from the wiring harness clip or strap.
3. Remove the automatic transaxle range selector cable from the automatic transaxle range selector lever.
4. Remove the automatic transaxle range selector cable from the automatic transaxle range selector cable bracket.
5. Remove the automatic transaxle range selector cable from the console shift control or the column shift control. Refer to Automatic Transmission
Range Selector Cable Replacement (At Console Shift Control) or Automatic Transmission Range Selector Cable Replacement (At Column Shift
Control).
6. Pull the automatic transaxle range selector cable through the dash from the engine compartment side.
INSTALLATION PROCEDURE
CAUTION: Refer to Automatic Transaxle Range Selector Cable Caution in Service Precautions.