Century V6-3100 3.1L VIN M SFI (1998)
Wiper Arm: Service and Repair
Wiper Arm Replacement
REMOVAL PROCEDURE
1. Turn the ignition switch to the ACCY position.
2. Set the wiper switch to the PULSE position.
3. Turn the ignition off when wiper arms are at the bottom of the wipe pattern (innerwipe) and not moving.
4. Disconnect the washer hose from the washer nozzle.
5. Remove the cover from the nut.
6. Remove the nut from the wiper arm and the wiper transmission drive shaft.
IMPORTANT: A J 39822 Wiper Arm Puller may be used if the wiper arm cannot be removed from wiper transmission drive shaft by rocking.
The pin from the new wiper arm may be used to ease removal.
7. Remove the wiper arm from the wiper transmission drive shaft by rocking.
8. Remove the wiper blade from wiper arm.
8.1. Push in the button of the wiper blade clip and remove the wiper blade from inside radius of wiper arm.
8.2. Bring the wiper arm out through the opening in the wiper blade.
INSTALLATION PROCEDURE
