Century V6-3100 3.1L VIN M SFI (1998)
1. Install the wiper blade on the wiper arm.
2. Install the wiper arm on the wiper transmission drive shaft.
2.1. Put the ignition switch in the ACCY position.
2.2. Set the wiper switch to the PULSE position. The windshield wiper system should be operating.
2.3. Turn the ignition off when the wiper drive system is at the bottom of its wipe cycle (innerwipe) and not moving.
IMPORTANT:
-
The measuring device must be held at 90° (perpendicular) to the wiper blade.
-
The pin, or a same-size drill bit, should be used in the wiper arm during installation.
Install the wiper arm on the wiper transmission drive shaft while maintaining the following distances:
-
RH 97-107 mm (3.82-4.21 in) from the end of the wiper arm to the air inlet screen.
-
LH 125-147 mm (4.92-5.78 in) from the wiper blade tip to the air inlet grille panel.
NOTE: Refer to Fastener Notice.
3. Install the nut onto the wiper transmission drive shaft and the wiper arm.
Tighten
Tighten the nut to 27 N.m (20 lb ft).
4. Remove the pin from wiper arm.
5. Install the cover on the nut.
IMPORTANT: Lubricate the washer hose with the windshield washer solvent to ease the installation on the washer nozzle.
6. Connect the washer hose onto the washer nozzle.
7. Operate the wipers and check for proper operation.
