buick Workshop Repair Guides

Buick Workshop Service and Repair Manuals

All Other Service Bulletins for Windshield:|88121|Page 7014 > < All Other Service Bulletins for Windshield:|88121|Page 7012
Page 3
background image

5.

Disconnect exhaust pipe at manifold.

6.

Verify that the following six bolts as shown in the Illustration are present:

(2)

A/C compressor-to-rear bracket bolts

(2)

Rear bracket-to-block bolts

(2)

Water pump-to-A/C compressor bolts

7.

Remove each of the above bolts, one at a time to prevent the compressor from "slipping".

IMPORTANT:

Remove upper, front compressor bolt after lowering vehicle.

8.

Inspect bolts for thread damage and/or wear due to loose operation. A damaged or missing bolt should be replaced with the appropriate part, per
the Illustration. Apply Loctite (R) 242 to the bolt threads during reinstallation. Loctite (R) 242 is available from GMSPO as Part Number
12345382.

IMPORTANT:

Inspect the threads of the A/C compressor's water pump attachment bosses. If damage is evident or if the bolts cannot be
torqued to the specification given, then the compressor should be fastened to the water pump using the following parts:

(2)

Bolts       Part Number 11502804

(2)

Washers      Part Number   120394

(2)

Jam Nuts     Part Number 11500424

Parts are currently available from GMSPO.

Refer to the Illustration for assembly and torque details.

9.

Apply Loctite (R) 242 to the bolt threads and torque to specification per the Illustration.

IMPORTANT:

It may be necessary to chase the threads of the two A/C brace attachment bosses to assure clean threads - use a M10 x 1.5
tap (see Illustration).

10.

Install the compressor support brace (P/N 10124667) with bolts (Part Number 11507023) as shown in the Illustration. Assure that the brace is
installed with the arrow pointing towards the compressor.

Parts are currently available from GMSPO.

11.

Connect exhaust pipe to the manifold.

12.

Install right side splash shield.

13.

Lower vehicle.

14.

Remove, clean, and Loctite (R) upper front compressor bolt.

15.

Install accessory drive belt.

16.

Replace the cracked A/C pipe with a new one.

17.

Connect battery.

18.

Recharge A/C system per the Service Manual and check for leaks.

WARRANTY INFORMATION

Labor Operation Number:

D3088 -  Hose Replacement

Labor Time:

.5 Hours

Add:

.5 Hours  -   Discharge/Charge A/C System

Trouble Code:

92

Labor Operation Number:

D4220 -   V5 Compressor Brackets

Labor Time:

.5 Hours

Trouble Code:

92

Labor Opertion Number:

T1412 - A/C Compressor Brace Installation

Labor Time:

.4 Hours

Trouble Code:

92

All Other Service Bulletins for Windshield:|88121|Page 7014 > < All Other Service Bulletins for Windshield:|88121|Page 7012