Century Estate Wagon V6-231 3.8L (1985)
1.
Remove cover harness connector. (See Illustration).
2.
Apply 12V(+) to #6 terminal.
3.
Pump should run and fluid should spray on windshield.
4.
If washer pump does not run, replacement is required; go to Step 11.
ITEMS NOT COVERED BY SPECIAL POLICY ARE STEPS 5 THROUGH 9
5.
If washer pump runs, but fluid does not spray on windshield, follow steps below:
6.
Remove washer bottle cap and examine filter screen at bottom of hose. Clean if necessary add washer fluid as required.
If gummy residue is found on filter screen, empty washer bottle, clean filter screen and bottle, and refill with approved GM washer fluid.
7.
Check for disconnected, leaking or pinched hoses. Correct as necessary.
8.
Inspect fluidic nozzles and check valve (if so equipped) for dirt, etc., clean if necessary.
9.
Reconnect all hoses and repeat Steps 2-3.
10.
If no fluid sprays, replace washer pump.
WINDSHIELD WASHER PUMP ASSEMBLY
11.
Disconnect washer pump retaining clip. (See Illustration).
