Electra V6-181 3.0L (1985)
B
25506534
25506530
25520262
10013779-JA1
22506314-JA1
22506315 JA3/JA5
C
25523352
25515955
25522565
25523353
1617075
E
25504652
25504363
1617759
1617075
G
25506533
25506531
25520262
1617075
X
25506532
25506531
25522221
1617075
J
25524318+
25512648
22515701
1617075
*
Bolt Circle + Includes medallion
CODE
LETTER COLOR
A
B,G,X
E
J
C
A
Red
14035631
22511949
25512649
14035631
1630024
B
Green
14035642
22511950
25512650
14035632
1630025
C
Brown
14035633
22511951
25512651
14035633
H
Gold
14035634
22511952
25512652
14035634
1630027
L
Black
14035635
22511953
25512653
14035635
1630028
Orange
1630029
Tan
1630030
Dark Brown
1630031
Silver
1630032
Gray
1630033
Blue
1630026
In addition to individual components, a complete lock wire wheel package (Option N91) is available through GMWDD for the 1985 models. Parts
numbers for these packages are as follows:
PART
NUMBER
MODEL
998568
Electra
997090
Riviera
997091
LeSabre (15" x 6" wheel) - JA1
997092
LeSabre (15" x 7" wheel) - JA3/JA5
997093
Regal
997094
Skylark
997788
Century (115 mm bolt circle) - JA1
998547
Century (110 mm bolt circle) - JA2/JA3/JA8
998697
Skyhawk (13" x 5.5" wheel)
When the vehicles is being made ready for delivery, the lock brackets are to be installed prior to installation of the wire wheel cover and medallions.
1.
Raise vehicle with lift equipment.
2.
Remove three (3) special lug nuts from each wheel for lock bracket installation - refer to illustrations.
3.
Place lock bracket on lug nut studs.
4.
Reinstall three (3) special lug nuts on each wheel to retain lock bracket and torque to specifications. LOOSE CONDITION OF LOCK BRACKET
MAY BE NORMAL. WHEN LUG NUTS ARE SEATED, FRONT WHEEL STUDS WILL HAVE A RECESSED APPEARANCE, WHICH IS
NORMAL
5.
Install adapter or anti-rotation clips if required.
6.
Install wheel cover on wheel.
NOTE:
The Electra (C) models use a new lightweight center retention. wire cover. This cover relies on the center lock bracket and fastener to
hold the cover on the wheel. It is important that installation instructions for the anti-rotation clips and cover are followed.
7.
Tighten lock bolt/nut with lock key wrench.
8.
Install center medallion.
9.
Install removal instruction label as required.
10.
The lock key wrench is to be placed in the glove box along with the I.D./Registration Card.