Electra V6-181 3.0L (1985)
b.
Battery Tray, Holddown Bolt and Plastic Clamp
Make sure acid residue has been thoroughly cleaned. Repaint tray as required.
c.
Lower Radiator Support and Radiator
Make sure acid residue has been thoroughly cleaned. Repaint affected areas as required.
d.
Upper Radiator Hose and Clamp at Radiator
Remove hose and replace clamp at radiator. Install new hose and clamp at radiator. Fill radiator with recommended coolant.
Torque clamps to 2.0 N-m. (18 in. lbs.).
e.
Windshield Washer Container Hose and Hood Release Cable
Replace washer container hose with service part number 1359744 cut to proper length. Replace hood release cable.
f.
Other Parts and Areas
Work performed and time allowance in the following areas must have zone approval:
(1.)
Left inner fender area,
(2.)
Left shock tower,
(3.)
Left horns,
(4.)
Air cleaner housing and inlet area,
(5.)
Hood insulation above battery. If battery acid is
evidenced on hood insulator, it should be replaced and inner hood panel should be cleaned and paint repaired, if
required.
(6.)
Engine cradle under battery,
(7.)
Other suspected contaminated parts in battery area.
FIGURE 3 - TRANSMISSION COOLER LINE HOSE INSTALLATION
5.. Place drain container under transmission cooler hoses.
6.
Remove transmission cooler hoses. If required, clean end of lines with a clean rag soaked in the baking soda and water solution; cover ends of
lines with tape and repaint affected areas. Remove tape. Install new hoses and clamps using parts in Kit 25526686. Refer to Figure 3. Torque
