Electra V6-231 3.8L VIN C SFI (1988)
Left Side*
1.
Cut the light blue wire approximately 3 inches back from the connector. Tape back the end going to the harness.
2.
Splice the three inch end of the light blue wire into the light green/black wire.
Right Side*
1.
Swap the light blue and yellow wires in the harness side of the connector.
2.
Cut the yellow wire approximately 3 inches back from the connector. Tape back the end going to the harness.
3.
Splice the three inch end on the yellow wire into the light green wire.
*
See Figure 1 for reference.
IMPORTANT:
Do not use the right or left mirror motor jumper harnesses.
2B.
1986 thru 1988 1/2 LeSabre; 1986 thru 1988 1/2 Electra/Park Avenue