Electra V6-231 3.8L VIN C SFI (1988)
Fig. 8 Stabilizer bar mounting
Fig. 9 Stabilizer bar replacement
1.
Raise and support vehicle and place jackstands under cradle. Vehicle weight should not be placed on the control arms.
2.
Remove wheel assembly.
3.
Install drive axle boot protectors.
4.
Remove nuts, washers, bushings and bolt securing stabilizer shaft to each control arm, Fig. 7.
5.
Remove stabilizer bar mounting bolts, two bolts from each side, Fig. 8.
6.
Disconnect tie rods from steering knuckles.
