Electra V6-231 3.8L VIN C SFI (1988)
Power Window Motor: Service and Repair
Window Regulator Tape
WINDOW REGULATOR TAPE
Tape Drive Regulator Service Parts
REMOVE OR DISCONNECT
1. Regulator from door.
2. Wire harness to regulator motor.
3. Window switch to wire harness.
4. Tape from tabs on regulator using a thin flat-bladed screwdriver
5. Rivet installed through tape and regulator using a 4.8 mm (3/16") drill bit - 6CH23-33 styles.
6. Tape from regulator by pressing window switch.
INSTALL OR CONNECT
1. Tape to regulator following listed steps:
^
Cut service tape to length needed.
^
Install guide and block assembly onto tape, making sure that tabs on guide and block assembly are into last three holes at end of tape.
^
Place tape in regulator channel and feed tape through channel until it is in contact with gear of regulator motor.
^
Run motor to complete installation of tape.
^
Place last four holes of tape on tabs of regulator.
^
Remove wire harness from regulator motor.
^
Remove wire harness from window switch.
2. Drill 4.8 mm (3/16") hole through service tape in line with hole in regulator on 6CH23-33 styles. Install a 3/16"x3/8" rivet through tape and
regulator.
3. Regulator to door inner panel.
