buick Workshop Repair Guides

Buick Workshop Service and Repair Manuals

Fuel - Injection Pump Pressure Adjusting & Diagnosis|Page 1215 > < Fuel - Injection Pump Pressure Adjusting & Diagnosis|Page 1213
Page 1
background image

Diesel MFI Pump: Technical Service Bulletins
Diesel Injection Pump Governor Weight Retainer

Bulletin  85-6C-9 Date  Jan.. '85 Ref. No.  85-098-6C

SUBJECT:

DIESEL INJECTION PUMP GOVERNOR WEIGHT RETAINER

MODELS AFFECTED: 1980-84 MODELS EQUIPPED WITH DIESEL ENGINES

A new governor weight retainer assembly, referred to as an "Elastomer Insert Drive" (EID) will be used on 1985 model injection pumps. This drive
mechanism consists of six viton rubber inserts in a self-contained drive mechanism. It is interchangeable with the rings used on 1980 through 1984
model diesel injection pumps.

You should use the new EID assembly when the repair to one of these 1980-84 pumps involves removal of the governor weight retainer assembly. Any
technician trained to install a governor weight retainer ring can install an EID. You should never clean or soak the EID in a caustic solution. If necessary
to clean, use diesel fuel or calibrating fluid only. The time allowance for the repair is unchanged, although the actual labor time is slightly less.

It is imperative that pumps reworked with the EID assembly be identified to assist you in future diagnosis if a pump problem is encountered. It is
extremely difficult to tell the difference between the drives once they are installed in the pump. A metal tag with the letter "E" is supplied in the package.
Install this metal tag under the cover screw on the right front cover of the pump. The tag should be placed between the flat washer and the star washer.
The star washer should go next to the cover.

Pumps that are within the 12 month/12,000 mile warranty period that are sent to a Roosa Master Dealer will have the new EID installed upon request.
There will be a charge for this, which will be the added cost of the EID. Roosa Master Dealers, in addition to the metal tag, will also stamp the body of
the pump with the letter "E". This identification will be located on top of the wrench boss on the front of the pump.

PARTS INFORMATION

Repair kits are available from eight GMWDD or a Roosa Master dealer.

GMWDD Part No. 22529991

Fuel - Injection Pump Pressure Adjusting & Diagnosis|Page 1215 > < Fuel - Injection Pump Pressure Adjusting & Diagnosis|Page 1213