buick Workshop Repair Guides

Buick Workshop Service and Repair Manuals

All Other Service Bulletins for Torque Converter Clutch Solenoid:|9074409|Page 3117 > < All Technical Service Bulletins:|8874406|Page 3114
Page 1
background image

Governor: All Technical Service Bulletins
A/T - Intermittent Delayed Upshifts

Bulletin:

90-7440-9

Date:

Apr. '90

Ret. No.:  90-099-7440

Corp. Ref. No.:  077106

SUBJECT:

INTERMITTENT DELAYED UPSHIFTS WHEN COLD OR HOT - TV PLUNGER/ BUSHING ASSEMBLY NOW AVAILABLE

MODELS AFFECTED:

ALL 1984-90 VEHICLES EQUIPPED WITH HYDRA-MATIC 4T60 (THM 440T4) TRANSAXLES

BULLETIN COVERS:

Background and diagnosis information on the throttle valve (T.V.) and governor system that control shift timing and not shift feel. The T.V.
plunger/bushing assemblies will now be available for service. Before the T.V. plunger/bushing assembly is replaced, the entire T.V. system must be
checked.  The T.V. SYSTEM may cause one or more of the following conditions:

-

Delayed upshifts (may also be caused by sediment between the governor seat and check balls).

-

Early upshifts (may also be caused by the governor weight(s) binding on the governor rotor). The rotor is not indexed correctly.

-

No upshifts (may also be caused by sediment between the governor seat and check balls).

-

1-2 shift at full throttle only.

-

No full throttle or part throttle detent downshifts.

-

Intermittent second gear starts.

-

Harsh 3-2 downshifts.

Figure 1 - T.V. Plunger/Bushing And Throttle Valve

IMPORTANT:

Some of the conditions listed above could be intermittent or all the time. The T.V. valve and bushing (Figure 1, Items 308 and 309) may be worn,
allowing sediment to cause the plunger to stick in the bore intermittently. Another concern could be the throttle valve (Figure 1, Item 311) stuck down in
the bore. Sediment could be the cause of both of these concerns. Either of these conditions could cause delayed upshifts when the transaxle is cold or hot.

The listed conditions may be caused by a T.V. cable that is:

-

Improperly adjusted

-

Kinked or binding

-

Disconnected

-

Broken

-

Wrong part

DIAGNOSIS:

^

Check T.V. cable for correct part number, listed in the parts catalog.

^

Check T.V. cable for kinked, binding, disconnected or broken condition.

All Other Service Bulletins for Torque Converter Clutch Solenoid:|9074409|Page 3117 > < All Technical Service Bulletins:|8874406|Page 3114