Electra Park Avenue V6-231 3.8L VIN C SFI (1989)
Figures 1 through 3
1.
Flywheel. Refer to applicable Service Manual.
2.
Timing chain and camshaft sprocket. Refer to applicable Service Manual.
3.
Balance shaft retainer bolts, retainer and gear.
4.
Thread J 6125-B into front end of balance shaft.
5.
Balance shaft using slide hammer action of J 6125-B.
6.
Balance shaft rear plug (except VIN K). Crankshaft rear main oil seal housing (VIN K).
7.
Install J 36995-5 to J 36995-3A and install assembly to rear of engine block.
8.
Install J 36995-2A to front of block and to end of J 36995 assembly using washer and nut provided.
9.
Balance shaft rear bearing (except VIN K), bushing (VIN K) by turning the nut on J 36995 assembly.
^
It may take a considerable amount of force to loosen the bearing and/or bushing from the bore.
Important:
Balance shaft, front bearing, rear bearing and/or bushing are serviced as a complete assembly.
Install or Connect