buick Workshop Repair Guides

Buick Workshop Service and Repair Manuals

Recall - Fuel Rollover Valve Assembly Missing|Page 3402 > < Recall - Fuel Rollover Valve Assembly Missing
Page 1
background image

Rollover Valve: Recalls
Vehicles Involved, Dealer, Owner & Parts Information

VEHICLES INVOLVED

Certain 1989 LeSabres built at Buick City within the following VIN breakpoints:

From

Through and Including

KH400026

KH401664

NOTICE:

Only 485 vehicles within this range are involved.

DEALER ACTION

Dealers are to replace the fuel sender and pump assembly on vehicles involved.

DEALER CAMPAIGN RESPONSIBILITY

Dealers are to service all vehicles subject to this campaign at no charge to owners, regardless of mileage, age of vehicle, or ownership, from this time
forward.

Whenever a vehicle subject to this campaign is taken into your new or used vehicle inventory, or it is in your dealership for service in the future, you
should take the steps necessary to be sure the campaign correction has been made before reselling or releasing the vehicle.

This bulletin is notice to you that the new vehicles included in this campaign may not comply with Federal Motor Vehicle Safety Standard No. 301.
Under National Traffic and Motor Vehicle Safety Act, Section 108, it is illegal for a dealer to sell a new motor vehicle which the dealer knows does not
comply with an applicable Federal Motor Vehicle Safety regulation. As a consequence, if you sell any of these motor vehicles without first performing
the campaign correction, your dealership may be subject to a civil penalty up to $1,000 of each such sale.

Owners of vehicles recently sold, from your new vehicle inventory are to be contacted by the dealer, and arrangements made to make the modification
according to instructions contained in this bulletin.

DEALER MATERIAL

If your dealership has vehicles involved in this campaign, you will receive the following items:

-

List of all vehicles involved in this campaign shipped to your dealership.

-

One (1) 89-C-1 kit containing Fuel Sender and Pump Assembly, Fuel O-ring Gasket and instruction sheet for each vehicle in your listing.

-

One (1) campaign identification label for each vehicle.

Involved vehicles have been identified by Vehicle Identification Number computer listings. Computer listings contain the complete vehicle identification
number, and have been furnished to the involved dealers.
OWNER NOTIFICATION

It is anticipated that there will be no owner notification required, since dealer invoicing was held on these vehicles.

SHIPMENT OF PARTS

The correct quantity of kits, Part Number 25027120, containing a Fuel Sender and Pump Assembly, Part Number 25094448, and fuel tank O-ring gasket
are being shipped to involved dealers on a "No Charge" basis. Parts will not be billed on dealer parts account.

Dealer should not order parts from GMSPO. If additional parts are necessary, contact your Zone or Branch Office.

Recall - Fuel Rollover Valve Assembly Missing|Page 3402 > < Recall - Fuel Rollover Valve Assembly Missing