buick Workshop Repair Guides

Buick Workshop Service and Repair Manuals

All Technical Service Bulletins for PROM - Programmable Read Only Memory:|916E21A|Page 3776 > < All Technical Service Bulletins for PROM - Programmable Read Only Memory:|916E21A|Page 3774
Page 3
background image

ENGINE DOES NOT STAY RUNNING ON INITIAL COLD START AND CHUGGLE AT 35-45 MPH AND WITH TORQUE CONVERTER
CLUTCH ENGAGED

Should owners' comments indicate both conditions exist. Follow steps outlined in both procedures. The two conditions are independent of each other.  If
it is determined that a new revised calibration MEM-CAL is necessary to correct both conditions, select MEM-CALS listed in Table B.

Note:
The new revised calibration MEM-CALS in Table B may affect fuel economy. Be sure to advise the vehicle owner of this fact.

TABLE "A" COLD STALL ONLY

Note:
Some 1991 LeSabre models with a 2.84 axle ratio and Federal emissions package had a PROM released that used Scanner ID 5644 but had a broadcast
code of AWJD. This should not be confused with 16165829 PROM which uses Scanner ID 5644 for a 2.97 axle ratio. DO NOT rely on the Scanner ID
to determine which PROM is in a vehicle. Look at the broadcast code on the PROM to be sure.

PARTS STATEMENT:

Parts are expected to be available on July 20, 1992. In case of limited inventory, parts will be placed on 400 control to waive VIP surcharges. Only
verifiable emergency VIP orders will be accepted. SPO will make every effort to obtain parts.  However, the part will be shipped premium transportation
at dealer's expense and all other order types will be placed on backorder until the 400 control is removed.

WARRANTY INFORMATION:

Labor Operations No.:
T0500

Labor Time:
.7 hr. (Replace MEM-CAL)
.2 hr. (Add to complete chuggle Diagnostic Flow Chart only)

All Technical Service Bulletins for PROM - Programmable Read Only Memory:|916E21A|Page 3776 > < All Technical Service Bulletins for PROM - Programmable Read Only Memory:|916E21A|Page 3774