Electra Park Avenue V6-231 3.8L VIN C SFI (1989)
Power Window Switch: All Technical Service Bulletins
Windows - Left/Right Switch Disengages From Armrest
Bulletin
89-10-6
Date
Jan., '89
Ref. No.
89-049-10
Corp. Ref. No.
801615
SUBJECT:
LEFT AND/OR RIGHT WINDOW SWITCH PLATE DISENGAGES FROM DOOR ARMREST PAD ASSEMBLY
MODELS AFFECTED:
1989 LESABRES
CONDITION
Some 1989 LeSabres may exhibit a condition where the left and/or right power window switch plate will not stay locked into the armrest pad assembly.
CAUSE
This condition is caused by excessive material at the rear edge of the armrest pad assembly. See Figure 1.
CORRECTION
1.
Remove switch plate using a thin bladed tool between armrest pad and rear of switch plate. Push tool forward to release switch plate retaining tab.
2.
Carefully loosen trim material at rear edge of armrest assembly. Using a sharp knife orifice, remove 1.5 mm stock from plastic housing at pad
assembly.
3.
Refold trim material into armrest assembly and check for proper engagement of switch plate into housing. Remove additional stock if required.
4.
Using a trim adhesive, re-cement trim material into housing and reinstall switch plate.
WARRANTY INFORMATION
Labor Operation Number:
T5183
Labor Time:
0.2 Hour
Trouble Code:
92