Electra Park Avenue V8-307 5.0L VIN Y 4-bbl (1984)
Figure 3
8.
Obtain bushing kit (part number 25111444). Install the bushing onto the bail as shown in Figure 3 so that the two tabs snap fimly in place. If the
bail is bent (or twisted) so that the new bushing will not easily snap into place on the bail (as shown in Figure 3), straighten the bail as necessary.
9.
Install the clip over the bushing and bail as shown in Figures 3 and 4. Reinstall the servo rod assembly through the new bushing by positioning the
"Z" pin as shown in View "A" of Figure 2. Reinstall the spring retainer in the original (marked) hole in the rod, pointing the spring retainer in the
direction shown in Figure 4.
If the servo rod assembly is missing the "Z" pin, install a second spring retainer in the end hole normally occupied by the "Z" pin.
10.
Ensure that the throttle mechanism will return fully to the idle position.
11.
Reinstall the air cleaner assembly and reconnect hose and electrical connections as may be appropriate.
12.
Install a Campaign Identification Label, remove fender cover from left fender, and close hood.
