Enclave AWD V6-3.6L (2009)
14. Connect the master cylinder fluid level sensor electrical connector (1).
Note: If necessary, a small amount of denatured alcohol may be used to aid installation of the brake booster vacuum sensor. Do not use soap.
15. Install the vacuum brake booster vacuum sensor (3).
Note: If necessary, a small amount of denatured alcohol may be used to aid installation of the brake booster check valve. Do not use soap.
16. Install the vacuum brake booster check valve and hose assembly (2) to the vacuum brake booster.
17. Install the windshield washer solvent heater. Refer to Windshield Washer Solvent Heater Replacement (Traverse) (See: Wiper and Washer
Systems/Washer Fluid Heater/Service and Repair)Windshield Washer Solvent Heater Replacement (Acadia, Enclave, OUTLOOK) (See: Wiper
and Washer Systems/Washer Fluid Heater/Service and Repair).
18. Install the air cleaner assembly. Refer to Air Cleaner Assembly Replacement (See: Engine, Cooling and Exhaust/Engine/Tune-up and Engine
Performance Checks/Air Cleaner Housing/Service and Repair).
