Enclave AWD V6-3.6L (2009)
Note:
*
Ensure that the marks on the camshaft position actuator and the timing chain (1-4) are aligned.
*
DO NOT tighten the camshaft position actuator bolt at this time.
1. Locate the camshafts to the cylinder head and assemble the camshaft actuators to the camshafts.
2. Install the camshafts and the camshaft bearing caps. Refer to Camshaft Installation - Left Side (See: Service and Repair/Overhaul).
3. Remove the EN-48313 .
Caution: Refer to Torque Reaction Against Timing Drive Chain Caution (See: Timing Components/Service Precautions)
Note: Use an open-end wrench at the camshaft hex to prevent camshaft/engine rotation.
4. Install and tighten the camshaft position actuators. Refer to Camshaft Position Actuator Installation - Left Side Intake (See: Service and
Repair/Overhaul) and Camshaft Position Actuator Installation - Left Side Exhaust (See: Service and Repair/Overhaul).
5. Install the intake camshaft position actuator solenoid. Refer to Camshaft Position Actuator Solenoid Valve Solenoid Replacement - Bank 2 (Left
Side) Intake (See: Actuators and Solenoids - Engine/Variable Valve Timing Solenoid/Service and Repair/Camshaft Position Actuator Solenoid
