Enclave AWD V6-3.6L (2009)
Note:
*
Ensure that the marks on the camshaft position actuators and the timing chain (15-18) are aligned.
*
DO NOT tighten the camshaft position actuator bolt at this time.
1. Locate the camshafts to the cylinder head and assemble the camshaft actuators to the camshafts.
2. Install the camshafts and the camshaft bearing caps. Refer to Camshaft Installation - Right Side (See: Service and Repair/Overhaul).
3. Remove the EN-48313 .
4. Install the crankshaft balancer. Refer to Crankshaft Balancer Replacement (See: Cylinder Block Assembly/Harmonic Balancer - Crankshaft
Pulley/Service and Repair).
Caution: Refer to Torque Reaction Against Timing Drive Chain Caution (See: Timing Components/Service Precautions)
Note: Use an open-end wrench at the camshaft hex to prevent camshaft/engine rotation.
5. Install and tighten the camshaft position actuators. Refer to Camshaft Position Actuator Installation - Right Side Intake (See: Service and
