Enclave AWD V6-3.6L (2009)
8. Remove the air cleaner housing cover (3) (with outlet duct).
9. Remove and discard the air cleaner element (4).
Installation Procedure
1. Install a NEW air cleaner element (4).
2. Position the air cleaner housing cover (3) (with outlet duct) onto the air cleaner lower housing.
3. Install the air cleaner outlet duct onto the throttle body.
4. Tighten the 6 air cleaner housing cover screws (2) until snug.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
5. Tighten the air cleaner outlet duct clamp (1) at the throttle body.
Tighten the clamp to 4 Nm (35 lb in).
6. Connect the engine wiring harness electrical connector to the MAF/IAT sensor.
