Enclave AWD V6-3.6L (2009)
2. Connect the engine wiring harness electrical connector (8) to the bank 2 intake CMP sensor (7).
3. Position and install the power steering fluid reservoir bracket (2).
4. Install the power steering fluid reservoir bracket bolts (1).
Tighten the bolts to 9 Nm (8 lb in).
5. Install the radiator inlet hose to the water outlet. Refer to Radiator Inlet Hose Replacement (See: Engine, Cooling and Exhaust/Cooling
System/Radiator Hose/Service and Repair).
6. Install the engine mount strut bracket. Refer to Engine Mount Strut Bracket Replacement - Right Side (See: Engine, Cooling and
Exhaust/Engine/Drive Belts, Mounts, Brackets and Accessories/Engine Mount/Service and Repair).
