Enclave AWD V6-3.6L (2009)
2. Install the fuel feed/EVAP pipe clip (2) and nut (3) to the stud.
Tighten the nut to 9 Nm (80 lb in).
3. Install the fuel feed/EVAP pipe clip (1) to the body.
4. Connect the EVAP canister vent front pipe quick connect fitting (5) to the chassis EVAP pipe. Refer to Plastic Collar Quick Connect Fitting
Service (See: Fuel Delivery and Air Induction/Fuel Line Coupler/Service and Repair/Plastic Collar Quick Connect Fitting Service).
5. Connect the fuel pump fuel feed pipe quick connect fitting (6) to the chassis fuel feed pipe. Refer to Plastic Collar Quick Connect Fitting Service
(See: Fuel Delivery and Air Induction/Fuel Line Coupler/Service and Repair/Plastic Collar Quick Connect Fitting Service).
6. Lower the vehicle.
7. Remove the caps from the fuel rail and the EVAP purge solenoid.
8. Connect the EVAP pipe (3) quick connect fitting to the EVAP purge solenoid. Refer to Plastic Collar Quick Connect Fitting Service (See: Fuel
Delivery and Air Induction/Fuel Line Coupler/Service and Repair/Plastic Collar Quick Connect Fitting Service).
9. Connect the fuel feed pipe (2) quick connect fitting to the fuel rail. Refer to Metal Collar Quick Connect Fitting Service (See: Fuel Delivery and
Air Induction/Fuel Line Coupler/Service and Repair/Metal Collar Quick Connect Fitting Service).
10. Tighten the fuel fill cap.
11. Use the following procedure in order to inspect for leaks:
*
Turn the ignition ON, with the engine OFF, for 2 seconds.
*
Turn the ignition OFF for 10 seconds.
*
Turn the ignition ON, with the engine OFF.
*
Inspect for fuel leaks.
12. Install the intermediate steering shaft. Refer to Intermediate Steering Shaft Replacement (See: Steering and Suspension/Steering/Steering
Column/Service and Repair/Intermediate Steering Shaft Replacement).
13. Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement (See: Fuel Delivery and Air Induction/Fuel Injector/Service
and Repair/Fuel Injector Sight Shield Replacement).
