Enclave AWD V6-3.6L (2009)
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
1. Install the CMP sensor (4) and bolt.
Tighten the bolt to 10 Nm (89 lb in).
2. Connect the engine wiring harness electrical connector (3) to the bank 2 exhaust CMP sensor (4).
3. Install the engine mount strut bracket. Refer to Engine Mount Strut Bracket Replacement - Right Side (See: Engine, Cooling and
Exhaust/Engine/Drive Belts, Mounts, Brackets and Accessories/Engine Mount/Service and Repair).
