Enclave AWD V6-3.6L (2009)
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
1. Position the knock sensor and tighten the knock sensor bolt.
Tighten the bolt to 23 Nm (17 lb ft).
2. Connect the engine wiring harness electrical connector (1) to the bank 1 knock sensor (2).
3. Install the exhaust manifold lower heat shield. Refer to Exhaust Manifold Lower Heat Shield Replacement (See: Engine, Cooling and
Exhaust/Exhaust System/Heat Shield/Service and Repair/Exhaust Manifold Lower Heat Shield Replacement).
