buick Workshop Repair Guides

Buick Workshop Service and Repair Manuals

All Technical Service Bulletins for Seat Belt Latch:|10243A|Page 10944 > < All Technical Service Bulletins for Seat Belt Latch:|10243A|Page 10942
Page 4
background image

4. Using a DREMEL(R), cut-off wheel, or similar tool, grind off/remove the cover's standing ledge material in the notched-out opening.

Note
Maintain the original notch out width (1) of approximately 82 mm (3.230 in) and remove the material until the surface edge is even with the
vertical wall surface (2).

5. After the material has been removed, file down any jagged edges or corners that may tend to snag the buckle material.
6. Reinstall the rear seat recliner inner trim cover. Refer to Rear Seat Recliner Outer Finish Cover Replacement - Inboard in SI.
7. After the rework and installation of the trim cover, verify proper function of the seat assembly.
8. Complete the rework on the trim cover for the opposite seat.

Courtesy Transportation - For US and Canada

The General Motors Courtesy Transportation program is intended to minimize customer inconvenience when a vehicle requires a repair that is covered
by the New Vehicle Limited Warranties. The availability of courtesy transportation to customers whose vehicles are within the warranty coverage period
and involved in a product program is very important in maintaining customer satisfaction. Dealers/retailers are to ensure that these customers understand
that shuttle service or some other form of courtesy transportation is available and will be provided at no charge. Dealers should refer to the General
Motors Service Policies and Procedures Manual for Courtesy Transportation guidelines.

Claim Information

1. Submit a claim using the table below. 

2. Courtesy Transportation - submit as Net Item under the repair labor code.

Customer Notification - For US and Canada

General Motors will notify customers of this recall on their vehicle (see copy of customer letter included with this bulletin).

Customer Notification - For Export

Letters will be sent to known owners of record located within areas covered by the US National Traffic and Motor Vehicle Safety Act. For owners
outside these areas, dealers should notify customers using the attached sample letter.

Dealer Recall Responsibility - For US and Export (US States, Territories, and Possessions)

All Technical Service Bulletins for Seat Belt Latch:|10243A|Page 10944 > < All Technical Service Bulletins for Seat Belt Latch:|10243A|Page 10942