Enclave AWD V6-3.6L (2009)
1. Install the wheel speed sensor to the steering knuckle.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
2. Install the wheel speed sensor bolt.
Tighten the bolt to 9 Nm (80 lb in).
3. Install the wheel speed sensor wire harness routing clips (4) and (5) to the suspension strut.
4. Insert the wheel speed sensor wire electrical connector (2) through the wheel house hole.
5. Seat the wheel speed sensor wire harness grommet (1) to the wheel house.
