Enclave AWD V6-3.6L (2009)
Note: Due to clearance issues, the upper attachment bolt cannot be removed from the APP sensor assembly. Loosen the bolt completely and leave
the bolt in the component until the assembly is removed from the vehicle.
4. Remove the APP sensor bolts and sensor assembly from the vehicle.
Installation Procedure
1. Install the upper bolt into the APP sensor assembly.
2. Install the APP sensor assembly into the vehicle.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
3. Install the remaining 2 lower APP sensor assembly bolts.
Tighten the bolts to 8 Nm (71 lb in).
