Enclave AWD V6-3.6L (2009)
7. Remove any plastic retaining clips on the power steering cooler pipe and discard them.
8. Remove the power steering cooler pipe from the vehicle.
Installation Procedure
1. Install the power steering cooler pipe to the vehicle.
2. Install a new power steering cooler pipe clamp (2).
3. Connect the power steering cooler pipe to the power steering gear outlet hose (4,3).
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
4. Install the power steering gear outlet hose bracket bolt (1) and tighten to 8 Nm (71 lb in).
5. Connect the power steering cooler pipe (3) to the power steering fluid cooler (1) and tighten the power steering cooler pipe clamp (2).
6. Clean any excess fluid from the vehicle and remove the drain pans.
7. Install the right front frontwards wheelhouse liner. Refer to Front Wheelhouse Front Liner Replacement (Traverse) ()Front Wheelhouse Front
