Enclave AWD V6-3.6L (2009)
5. Install the power steering gear inlet hose bracket and bolt (1) and tighten to 8 Nm (71 lb in).
6. Install the power steering gear inlet hose bracket and nut (2) and tighten to 8 Nm (71 lb in).
7. Connect the power steering fluid reservoir outlet hose to the power steering pump. Refer to Power Steering Fluid Reservoir Outlet Hose
Replacement (See: Power Steering Fluid Reservoir Outlet Hose Replacement)
8. Clip the power steering fluid reservoir outlet hose to the power steering gear inlet hose bracket.
9. Clean any excess fluid from the vehicle and remove the drain pans.
10. Install the right side catalytic convertor. Refer to Catalytic Converter Replacement - Right Side (See: Engine, Cooling and Exhaust/Exhaust
System/Catalytic Converter/Service and Repair/Catalytic Converter Replacement - Right Side)
11. Fill and bleed the power steering system. Refer to Power Steering System Bleeding (See: Power Steering Bleeding/Service and Repair).