Enclave AWD V6-3.6L (2009)
8. Disconnect the rubber segment from the metal segment of the power steering gear outlet hose (3, 4).
9. Remove any plastic retaining clips on the power steering gear outlet hose and discard them.
10. Remove the power steering gear outlet hose from the vehicle.
Installation Procedure
1. Position the power steering gear outlet hose to the vehicle.
2. Position a new power steering gear outlet hose clamp (2).
3. Connect the rubber segment to the metal segment of the power steering gear outlet hose (3, 4).
4. Crimp the new power steering gear outlet hose crimp clamp.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
5. Install the power steering gear outlet hose bracket bolt (1) and tighten to 8 Nm (71 lb in).
6. Insert the steering gear outlet hose in to the steering gear.
