Enclave AWD V6-3.6L (2009)
11. Install the upper mount.
12. Raise the suspension crossmember and rear drive module.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
Note: If the suspension crossmember mount bolt does not screw in smoothly, run a tap through the suspension crossmember nut in the body in
order to remove foreign material. Ensure the tap does not punch through the underbody.
Do not over tighten the body mount. Over tightening may collapse a spacer or strip a bolt.
13. Install the suspension crossmember to body bolts.
Tighten the bolts to 110 Nm (81 lb ft) plus 90 degrees.
14. Install the rear axle differential to body bolt.
Tighten the bolts to 160 Nm (118 lb ft).
