Enclave AWD V6-3.6L (2009)
Note: The engine and transmission mount nuts must be replaced once removed. When the nut has to be loosened or removed, threadlocker must
be used in addition to using a new nut. Allow adhesive on new engine and transmission mount nuts to cure for 24 hours after replacement.
18. Apply threadlocker GM P/N 12345382 (Canadian P/N 10953489) to the engine and transmission mount threads.
19. Install the engine and transmission mount nuts and tighen to 75 Nm (55 lb ft).
20. Install the power steering cooler inlet pipe to the frame. Refer to Power Steering Cooler Pipe/Hose Replacement (See: Steering/Power
Steering/Power Steering Line/Hose/Service and Repair/Power Steering Cooler Pipe/Hose Replacement).
21. Install the power steering gear to the frame. Refer to Steering Gear Replacement (See: Steering/Steering Gear/Service and Repair).
22. Install the power steering gear bolts. Refer to Steering Gear Replacement (See: Steering/Steering Gear/Service and Repair).
23. Install the power steering gear heat shield. Refer to Steering Gear Heat Shield Replacement (See: Steering/Steering Gear/Service and Repair).
