Enclave AWD V6-3.6L (2009)
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
2. Install the transmission mount bracket bolt (3) and tighten to 90 Nm (66 lb ft).
3. Install the transmission mount bracket bolt (1) and tighten to 90 Nm (66 lb ft).
4. Using the transmission jack, lower the transmission until the transmission mount bracket rests on the transmission mount.
5. Install the transmission mount bracket bolt (2) and tighten to 90 Nm (66 lb ft).
6. Remove the transmission jack.
7. Install the transmission mount nut (2) and tighten to 75 Nm (55 lb ft).
8. Install the transmission mount nut (1) and tighten to 90 Nm (66 lb ft).
9. Install the left engine splash shield. Refer to Engine Splash Shield Replacement (See: Body and Frame/Splash Guard/Service and Repair).
10. Lower the vehicle
