Enclave AWD V6-3.6L (2009)
9. Remove the wire harness retainer (2) from the control valve body cover stud.
10. Disconnect the control valve body transmission control module (TCM) electrical connector (1).
11. Remove the 2 control valve body cover studs M6 x 30.
12. Remove the 12 control valve body cover bolts M6 x 30.
13. Support the transmission with a transmission jack.
14. Using the transmission jack raise the transmission to gain clearance for removal of the control valve body cover.
15. Remove the control valve body cover.
16. Remove the control valve body cover gasket.
Caution: Support the control solenoid valve assembly around the connector when removing the seal. Excessive pulling force can damage the
internal electrical connections.
17. Remove all traces of the old gasket material. Clean the transmission case and control valve body cover gasket surfaces.
18. Remove the control valve body cover wiring connector hole seal from the TCM.
Installation Procedure
