Enclave AWD V6-3.6L (2009)
10. Using the J 35910 - Drive Axle Seal Clamp Pliers (3), ratchet wrench (4) and a breaker bar (5), close the boot clamp (1) until the gap (6)
measures 1.9 mm (0.07 inch).
11. Remove any of the excess lubricant from the tripot housing and wheel drive shaft.
12. Move the tripot joint housing in a circular motion to distribute the lubricant in the tripot housing.
13. Remove the wheel drive shaft from the vise.
14. Install the wheel drive shaft in the vehicle. Refer to Front Wheel Drive Shaft Replacement (See: Service and Repair/Front Wheel Drive Shaft
Replacement).
