Enclave AWD V6-3.6L (2009)
Caution: Do not cut through the wheel drive shaft inboard or outboard boot during service. Cutting through the boot may damage the sealing
surface of the housing and the tripot or the constant velocity joint bushing. Damage to the sealing surface may lead to water and dirt intrusion and
premature wear of the constant velocity joint.
3. Use a flat-bladed tool, remove the boot clamp (2) from the constant velocity (CV) joint (1) and the boot (3).
4. Using a pair of side cutters, remove the boot clamp (4) from the boot (3) and the wheel drive shaft (5).
5. Discard the boot clamps (2) and (4). Use NEW clamps only.
6. Using a block of wood and a hammer, remove the CV joint (2) from the wheel drive shaft (1).
7. Remove the boot (1) from the wheel drive shaft (2).
8. Inspect the outer CV joint for damage and wear. Refer to Wheel Drive Shaft Outer Joint Inspection (See: Testing and Inspection/Wheel Drive
Shaft Outer Joint Inspection).
Assemble Procedure
