Enclave AWD V6-3.6L (2009)
5. Install the boot clamp (4) on the boot (3) and the wheel drive shaft (5).
6. Install the boot clamp (2) on the boot (3) and the CV joint housing (1).
Note:
*
Ensure that the boot clamp is properly positioned around the entire circumference of the boot.
*
Ensure that the gap measurement does not exceed 1.9 mm (0.07 in).
7. Using the J 35910 - Drive Axle Seal Clamp Pliers , tighten the boot clamp (2) until the gap (3) in the boot clamp measure 1.9 mm (0.07 in).