Enclave AWD V6-3.6L (2009)
1. Install the window regulator motor (6) to the regulator. Refer to Door Window Regulator Motor Replacement (See: Power Window
Motor/Service and Repair/Door Window Regulator Motor Replacement).
2. Partially install the upper bolt (3) to the regulator (5).
3. Beginning with the upper portion, install the regulator through the door opening in a semi-horizontal position.
4. Position the regulator fully forward into the door cavity.
5. Rotate the regulator to a vertical position.
6. Lower and hang the regulator onto the door sheet metal using the upper bolt (3) that were previously installed.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
7. Install the nut (2) that retains the motor to the door.
Tighten nut to 9 Nm (80 lb in).
8. Install the upper and lower bolts (3, 4) that retain the regulator to the door.
Tighten bolts to 10 Nm (88 lb in).
9. Connect the electrical connector to the regulator motor.
10. Remove the window support and lower the window to the window guide on the regulator.
11. Loosely tighten the regulator window carrier bolts.
12. Operate the window upward to the full up position, ensuring the window remains in the run channels.
13. Install the energy absorber retainers and energy absorber to the door.
14. Install the covers that conceal the regulator bolt holes.
15. Install the water deflector. Refer to Rear Side Door Water Deflector Replacement (See: Body and Frame/Doors, Hood and Trunk/Doors/Rear
Door/Rear Door Panel/Service and Repair).
16. Install the door trim panel. Refer to Rear Side Door Trim Panel Replacement (Traverse) (See: Body and Frame/Doors, Hood and
Trunk/Doors/Rear Door/Rear Door Panel/Service and Repair)Rear Side Door Trim Panel Replacement (Acadia/OUTLOOK) (See: Body and
Frame/Doors, Hood and Trunk/Doors/Rear Door/Rear Door Panel/Service and Repair)Rear Side Door Trim Panel Replacement (Enclave) (See:
Body and Frame/Doors, Hood and Trunk/Doors/Rear Door/Rear Door Panel/Service and Repair).
