Enclave AWD V6-3.6L (2009)
6. Reposition the front door sealing weatherstrips in order to access the side reveal molding screws.
It is not necessary to remove the front door sealing weatherstrip completely from the vehicle.
7. Remove the side of the reveal moldings.
8. Remove the rearview mirror. Refer to Inside Rearview Mirror Replacement (See: Body and Frame/Mirrors/Service and Repair/Inside Rearview
Mirror Replacement).
9. Remove the rain sensor, if equipped.
Note: The windshield lower supports (1) have molded in locks with an adhesive strip (2) on the back side. If the windshield lower stops have been
removed, they must be replaced.
10. Remove the windshield lower supports (1) by using a flat-bladed tool, lightly prying upward in the middle until it releases, if damaged.
Warning: Refer to Glass and Sheet Metal Handling Warning (See: Body and Frame/Service Precautions/Technician Safety
Information/Glass and Sheet Metal Handling Warning).
Note: Keep the cutting edge of the tool against the window.
11. This will allow the urethane adhesive to be separated from the window.
*
Leave a base of urethane on the pinch-weld flange.
*
The only suitable lubrication is clear water.
*
Use J 24402-A , J 39032 or equivalent in order to remove the window.
