Enclave FWD V6-3.6L (2008)
Keyless Entry Transmitter: Service and Repair
Transmitter Programming
Next Available Slot
Important:
*
On some vehicles, keyless entry transmitters may also be programmed using the driver information center (DIC). Refer to the vehicle
owners manual for information.
*
Do not operate or program the transmitters in the vicinity of other vehicles that are in the keyless entry program mode. This prevents the
programming of the transmitters to the incorrect vehicle.
This procedure will program keyless entry transmitters in sequential order. If two transmitters are currently learned to the vehicle as transmitters 1 and 2,
using this procedure will learn the next transmitter are transmitter 3, and so on.
1. With a scan tool, access the Remote Control Door Lock Receiver Module Setup menu. Select Program Key Fobs.
2. Select Next Available Slot. The vehicle chime will sound two times to indicate programming mode has been entered. Follow the on-screen
instructions. After each transmitter has been programmed, the vehicle chime will sound to confirm the programming.
3. When all the desired transmitters have been programmed, cycle the ignition from ON to OFF, exit the vehicle, and operate the transmitter
functions in order to verify correct system operation.
Invalidate All Fobs
Important:
*
On some vehicles, keyless entry transmitters may also be programmed using the driver information center (DIC). Refer to the vehicle
owners manual for information.
*
All transmitters which are to be recognized by the remote control door lock receiver (RCDLR) must be programmed in a single
programming sequence. Once the Invalidate All Fobs selection is made, all learned transmitters are erased. If all the existing transmitters
associated with the vehicle are not learned at this time, they will become inoperative and require additional programming.
*
Do not operate or program the transmitters in the vicinity of other vehicles that are in the keyless entry program mode. This prevents the
programming of the transmitters to the incorrect vehicle.
This procedure will first erase all known keyless entry transmitters. After all transmitters are erased, the procedure will being to program keyless entry
transmitters in sequential order, beginning with transmitter 1.
1. With a scan tool, access the Remote Control Door Lock Receiver Module Setup menu. Select Program Key Fobs.
2. Select Invalidate All Fobs. This will erase all learned transmitters and prepare the RCDLR to learn new transmitters. Follow the on-screen
instructions. After each transmitter has been programmed, the vehicle chime will sound to confirm the programming.
3. When all the desired transmitters have been programmed, cycle the ignition from ON to OFF, exit the vehicle, and operate the transmitter
functions in order to verify correct system operation.
