Enclave FWD V6-3.6L (2008)
battery runs low.
Correction
1. Inspect the liftgate touch pad function. Also check for DTC B2494 failure code 02.
2. Inspect the shut face function. Also check for DTC B2494 failure code 02. The touch pad and the shut face run in parallel, so check each switch
separately. Replace the close switch if water is present in the switch and make sure the grommet on the wiper arm shaft to the outer panel is seated
properly. If the grommet is loose, apply a small amount of weatherstrip adhesive in the grommet's U channel and reinstall the grommet (Buick
Only).
3. Inspect the sill plate for proper installation/clearance to the touch pad switch and possible bent retainers.
Condition #3
Power liftgate reverses while closing at the start (top) of travel.
Cause
1. Strut stanchion (strut dries out while sitting open for long periods)
2. Key fob sending a second hit signal (Some key fobs will send a second hit signal upon release of the button, others if you roll your thumb while
holding down the button or a combination of the two together). Refer to the Cause and Correction for Condition #8.
3. Low battery voltage.
Correction
1. Close the gate manually after the gate has remained open for extended periods.
2. Inspect the key fob operation.
3. Charge the battery.
Condition #4
Power liftgate reverses while closing mid travel.
Cause
1. Strut stanchion (strut dries out while sitting open for long periods).
2. Key fob sending a double hit signal (Some key fobs will send a second hit signal upon release of the button when held longer than 1 second, others
will send a second signal if you roll your thumb while holding down the button or a combination of the two together).
3. Someone getting into the vehicle while the gate is closing (If you jump into the vehicle while the liftgate is closing, you can cause a reversal in mid
travel).
Correction
1. Close the gate manually after the gate has remained open for extended periods. One time should be sufficient.
2. Inspect the key fob operation.
3. Do not jounce the vehicle while the PLG is in motion. Sit lightly into vehicle while PLG is in operation.
Condition #5
Power liftgate reverses while closing when almost closed.
Cause
1. An obstruction behind the 3rd row seat.
2. The sill plate is not seated correctly (Not seated fully / bent attachments).
