Enclave FWD V6-3.6L (2008)
3. The side reveal molding pins are not fully seated, causing the trim to not fully seat (Buick).
4. The rubber bumpers on the liftgate in the lower corners may not be fully seated (GMC / Saturn).
5. The striker may be out of alignment.
6. The striker was moved forward or backward.
7. The liftgate may not be flush to the fascia.
8. The primary seal may not be fully seated.
Correction
1. Remove the obstruction.
2. Inspect the sill plate for installation and possible bent retainers.
3. Push in the side reveal molding retainers.
4. Turn the bumpers in fully.
5. Align the striker. Perform the Liftgate Calibration Procedure.
6. Perform the liftgate calibration procedure.
7. Move the striker rearward to flush out gate and relearn. Marking the current location of the liftgate striker, loosen the striker bolts and strike the
striker rearward with a mallet to adjust the liftgate striker outboard (to the rear of the vehicle). Only move the striker in 1‹›mm increments,
performing the Liftgate Calibration Procedure after each adjustment.
8. Glue the primary seal down.
