Enclave FWD V6-3.6L (2008)
Important:
Make sure there are no dips in the hose after the extension has been added. Refer to the illustration. In some cases, it may be necessary to trim
off some of the drain tube to eliminate the dip in the drain tubing.
4.
The drain hose should be straight with a slight downward angle to the rear of the vehicle.
Check Drain Hose Routing Between the "B" and "C" Pillar for Proper Routing
1.
After installing the extensions, make sure that the hose is routed in back of the air bag bracket. Figure 1 is the incorrect routing; Figure 2 shows the
correct routing.
2.
Make sure that there are no bends pointing upward in the drain tubes.
Check All Drain Hose Connections and Add Tie Straps
1.
Check the front and rear sunroof drain hose connections to make sure they are fully seated and add a tie strap to each front and rear connection.
Clip off excess lead with wire snips.
2.
Reinstall the headliner following SI procedures.
Modify Front Drain Hoses
1.
Remove the "A" pillar trim and defroster outlet grille to gain access to the end of the drain tubes.
