Enclave FWD V6-3.6L (2008)
Sunroof / Moonroof Motor: Testing and Inspection
Sunroof Motor/Actuator Initialization/Teach Process (New Motor)
Sunroof Motor/Actuator Initialization/Teach Process (New Motor)
Perform the initialization/teach procedure at first operation test of the sunroof. Ensure the electrical harness on the headliner is connected to the large
roof, battery power is applied, and the ignition switch is ON.
1. Press the sunroof switch to the vent open position until the window stalls at the front hard stop in the vent open position, and then moves slightly to
the soft stop position. Release the button.
2. Within 3 seconds, press and hold the sunroof switch vent open again. The sunroof window will move toward and past the flush position.
3. Continue holding the switch until the sunroof window moves to full open and then back to close and stops at the closed position. Release the
button. The initialization/teach procedure is complete.
4. Verify the operation of the sunroof.
The initialization/teach procedure is not complete if one of the following events occurs before the initialization/teach cycle is done:
*
The sunroof switch is not held in the vent open position.
*
Ignition and/or battery power has been removed.
*
The glass panel has not reached the close position.
If the initialization/teach procedure is not carried out completely, it has to be started again.
