Enclave FWD V6-3.6L (2008)
6. Using a metric ruler, measure from the front end of the upper rail (1) to the front end of the lower rail (2) on the inboard track section.
7. Using a metric ruler, measure from the front end of the upper rail (1) to the front end of the lower rail (2) on the outboard track section.
8. If the measurements are within 3 mm (0.12 in) from each other, proceed to step 10. If the difference in the measurements is greater than 3 mm
(0.12 in), the track section must be timed. Proceed to step 9.
9. Horizontally power the seat (fore or aft) to cause the outboard track section to get a measurement within 3 mm (0.12 in) of the inboard track
section. The track sections are now in time.
Important
Be sure to install the correct new drive cable based on whether the seat has a metal motor bracket or a plastic motor bracket.
10. Insert one end of the new drive cable into the horizontal motor until fully seated. If the seat is a memory seat, the longer unflocked end of the drive
cable will be inserted into the motor.
11. Take the opposite end of the drive cable and insert into the horizontal transmission on the inboard track section. The drive cable may need to be
