Enclave FWD V6-3.6L (2008)
3. Clean the mounting area and prepare the area for welding.
4. Install the pin into the hole. Note that the pin has an anti-rotation feature and will only fit in one position.
5. Clamp the pin in position.
6. Mig weld the pin in the locations as shown.
7. Apply a protective coating to the weld repair area, such as GM P/N 89021939 (in Canada, P/N 992651) Low Gloss Spray Paint Black, or the
equivalent.
8. Cycle the recliner mechanism and verify that the stop pin, the actuator and the cables are functioning correctly.
9. Reinstall the rear seat adjuster assembly. Refer to Rear Seat Adjuster Replacement (with 60 Percent Seat) in SI.
3. With the seat assembly installed, verify the proper operation of the "Easy Entry" function.
Parts Information
Fax the form included in this bulletin to the WPC in order to obtain this part.
Warranty Information
For vehicles repaired under warranty, use the table above.
