Enclave FWD V6-3.6L (2008)
Wheel Speed Sensor: Service and Repair
Rear Wheel Speed Sensor Replacement
Rear Wheel Speed Sensor Replacement
Caution: Refer to Brake Dust Caution .
Important: If replacing the wheel speed sensor due to a DTC, inspect the back of the wheel bearing on the encoder surface for metallic chips or
metal shavings. If metallic debris is found, clean the encoder surface to prevent interference with the wheel speed sensor signal and setting of a
DTC. Refer to Diagnostic System Check - Vehicle to verify and clear the DTC.
Removal Procedure
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
3. Disconnect the wheel speed sensor electrical connector (1).
4. Release the wheel speed sensor wire harness grommet (2) from the lower control arm bracket.
5. Release the wheel speed sensor wire harness routing clips (3) from the upper suspension link.