Enclave FWD V6-3.6L (2008)
14. Remove the brake pedal pushrod retaining clip (1).
15. Remove the brake pedal pushrod clevis pin (2) and disconnect the pushrod from the brake pedal.
16. Remove the intermediate steering shaft. Refer to Intermediate Steering Shaft Replacement .
17. Remove the 4 vacuum brake booster nuts.
18. Pull the vacuum brake booster forward and tilt upward slightly until the mounting studs clear the dash panel.
19. Remove the vacuum brake booster.
Installation Procedure
Important: Inspect the vacuum brake booster to dash panel gasket for damage and replace, if necessary.
