Enclave FWD V6-3.6L (2008)
11. Position the BPMV assembly over the studs.
12. Install the 2 nuts (2) to the BPMV and bracket assembly.
Tighten the nuts to 20 N.m (15 lb ft).
13. Install the front and rear brake pipes (1) to the routing clip on the frame rail.
14. Connect the master cylinder fluid level sensor electrical connector (1).
Important: If necessary, a small amount of denatured alcohol may be used to aid installation of the brake booster vacuum sensor. Do not
use soap.
15. Install the vacuum brake booster vacuum sensor (3).
Important: If necessary, a small amount of denatured alcohol may be used to aid installation of the brake booster check valve. Do not use
soap.
